13
Note - If the appliance battery power is becoming low, a continuous beeping sound will be heard
from the control unit every time the appliance is operated.
If you have any questions or the appliance is not operating correctly, phone the Burley help-line
BEFORE you leave the installation.
If the appliance is not fitted in strict accordance with these instructions, Burley cannot be held
responsible for any damage caused and reserve the right to charge for any corrective work.
Note: When lighting the fire from very cold, it may sometimes switch itself off after about 20
seconds. This is the very sensitive oxygen depletion circuit proving itself and is normal. Wait for 1
minute and relight fire. If this continues to happen more than 3 or 4 times from cold then seek
advice. To avoid this happening it is possible to leave the pilot alight at all times.
10.2
Remote Operation
10.2.1 Batteries – The handset takes a standard 9v battery. This should be changed annually to
ensure the fire continues to operate correctly. It can be accessed through a flap on the back of the
handset.
The fire is fitted with a special 7.2volt Lithium battery available from your retailer or from Burley
Appliances on 01572 756956. In normal use, this will last between 6 and 9 months. It can be
changed by simply sliding it out of its housing under the fire, undoing the connector block and
carefully replacing with a new one.
The fire should be switched OFF at the toggle switch when not in use to prevent unnecessary drain
on the battery and extend battery life. Be sure to brief the user on this as it will extend battery life
considerably. Be sure to brief the user on this as it will extend battery life considerably. We regret
that the warranty does not cover items such as batteries.
When disposing of batteries, always do so in an environmentally friendly manner.
10.2.2
Ensure the toggle switch behind the trim is switched to the ON position.
10.2.3
On first operation, ensure the thermostat is set to the hot position.
10.2.4
Ensure the infra red sensor is visible. The fire relies on line of sight between the sensor and
handset to operate. In the event of the fire not working check the above points before calling an
engineer.
10.2.5
To ignite the fire point the handset at the fire, push and hold simultaneously the 2 left hand
buttons marked * and
●
for several seconds until the ignition sequence begins. The fire will
automatically light the pilot light, monitor its safety for about 20 seconds and then it will light the
burner on high flame.
