Page 4 of 20
Battery Replacement
Handset
1.7
On the back of the handset remove the battery cover by pressing down the top of the
cover & sliding it down.
Remove & unclip the old battery & replace with a new PP3 9
volt battery.
Receiver Unit (located under burner)
Remove the heat shield surrounding the unit. Pull the receiver unit out from underneath
the burner & remove the top cover. Remove old batteries & replace with four new AA
batteries ensuring the polarities are correct. Replace the battery cover & return the
receiver unit to its original position. REPLACE THE HEATSHIELD over the unit.
Press here and
slide down
CAUTION:
With the exception of battery replacement, the battery holder must be
located within the heat shield
at all times
.
Programming Handset to Receiver
If for some reason the remote handset requires re-programming to operate the receiver follow
the procedure below:
1.
Press and hold, using a pointed object, the receiver’s reset button until you hear two acoustic
signals.
2.
After the second longer acoustic signal, release the reset button and within the subsequent 20
seconds, press the (small flame) on the remote handset until you hear an additional long
acoustic signal confirming the new code is set.
RESET
