Burley Tools 35300, User Manual, Page: 32 / 33

U
živatelská příručka k elektrickému míchadlu
35300
Page 32 of 33
Cleaning
_ Keep the safety devices, ventilation slots and Motor housing as free of dirt and dust as possible.
Clean the unit by rubbing it with a clean cloth or blow it clean using low-pressure compressed air.
_ We recommend that you always clean the unit immediately after using it.
_ Do not use cleaners or solvents; these will attack the plastic parts in the unit. You must also
ensure that water cannot get into the inside of the unit.
Carbon brushes
_ If excessive sparking occurs you must have the carbon brushes checked by a qualified electrician.
Attention! Only a qualified electrician is allowed to change the brushes.
Maintenance
_ There are no parts fitted inside the unit that require maintenance.
For your own safety, never remove parts or accessories of the electric tool during operation.
In case of fault or damage have the electric tool repaired only by a specialist workshop or by
the manufacturer.
9) LABELS ON YOUR TOOL (IF ANY)
V Volts Hz Hertz
Alternating current W Watts
n
0
No load speed /min or
min
-1
Revolutions or reciprocation
per minute
Class II tool To reduce the risk of injury,
user must read instruction
manual
Wear Ear Protection
Wear Eye Protection
10. ENVIRONMENTAL PROTECTION
Do not dispose of in general household waste. Instead dispose of in an
environmental friendly way, contact your local recycling centre of council
for advice. Please take the care of the environment very seriously.