Bürkert 8619 multiCELL WM AC, Operating Instructions Manual

Page: 56 / 194

7.3.12 Wiring the Industrial Ethernet
WARNING
Risk of injury due to non-conforming installation.
▶
Electrical installation can only be carried out by qualified and skilled staff with the appropriate tools.
RJ45 port Pin Pin assignment
12345678
1 TX+
2 TX–
3 RX+
4 N. C.
5 N. C.
6 RX–
7 N. C.
8 N. C.
Housing FE
Fig. 23 : Pin assignment of each RJ45 port
You can prepare a connection cable for wall-mounted version as described below, or you can use an adapter
RJ45-M12. See chap. 10, page 190.
Preparing a connection cable for a wall-mounted version:
→
Choose an RJ45 male connector for industrial use
Shielded cable minimum required: FTP
Minimum category 5e / CAT-5
Length max. 100 m
→
To make sure the door of the device can be fully closed, use RJ45 male connectors with maximum dimensions
of 45 mm including the bend radius of the Ethernet cable.
→
Insert the cable via the cable gland of the device.
→
Insert the wires as specified by the manufacturer of the RJ45 male connector and according to
ISO / IEC 11801.
→
Crimp the RJ45 male connector.
→
Insert the RJ45 connector in the RJ45 port.
→
Do the settings of the Ethernet connection. Refer to the Supplement related to the Type 8619 Industrial Eth-
ernet protocol (Operating Instructions of the Industrial Ethernet protocols), available on:
www.burkert.com .
56
Installationandwiring
Type 8619
English