Bürkert 0911, Operating Instructions Manual, Page: 9 / 84

0911 - 7
english
2.3 Before the installation
PREDEFINE THE SENSOR TYPE
Hold down the SET + button for at least 3
seconds.
Select the parameter Pbc (sensor type) and then
confirm with the SET button to see the current
default.
Type TU (temperature controller) :
J = Thermoelement J; Pt = Pt100;
K = Thermoelement K; Ptc = PTC;
S = Thermoelement S; ntc = NTC
Type AU
(control devices with current/voltage input) :
cur = 4...20 mA; 0-1 = 0...1 V; 10 = 0...10 V
Confirm the default with the SET button.
Briefly switch off the power to the device.
The configurable input type is noted on the controller
label. Enter this input type if it corresponds to the
connected sensor type.
LOCKING AND UNLOCKING THE KEYPAD
Hold down the buttons and for at least 3
seconds. The message POF appears on the
display. The keyboard is locked . You can only
view the set-value and the minimum and maximum
temperature. The POF message also appears if
you hold down a button for longer than 3 s.
The keyboard will be unlocked if you hold
down the buttons and for 3 s. POn appears
in the display for a few seconds.
CHANGING THE DEFAULT PARAMETERS
Enter a desired value with SET + or .
Then confirm with the SET button.
Enter a desired parameter with or .
NOTE All parameter values can be seen by repeatedly pressing the
SET buttons.