Burkert Flowave 8098, Operating Instructions Manual

Page: 235 / 354

235
SAW sensor – Parameter
Type 8098 FLOWave L
→
Do the settings for a special event (see
chapter 15.14.1 , 15.14.2 , 15.14.3 and 15.14.4 ).
Is the event associated to the device
status None ?
Yes
The event is disabled.
No
Is the event associated to the device
status Normal state
1)
?
Yes
• The event cannot be signalled by an
analogue output.
• If the event is enabled, a message is
generated if the event occurs.
No
→
Choose the behaviour of the analogue output(s)
for each device status ( Failure , Out of specifi-
cation and Maintenance required ).
Is a digital output configured as an on/
off output? See chapter 18.5.1 .
No
The event cannot be signalled by a
digital output.
Yes
If the event is enabled, it can be signalled by a digital output
configured as an on/off output.
The on/off output can be configured to switch:
• depending on this single event.
• and/or, depending on Failure , Out of specification or Main-
tenance required events.
→
Activate the Diagnostics in General settings –
PARAMETER . See chapter 12.10 .
Fig. 64: Flowchart: configuration of the diagnostics
1)
Normal state means that only a message is generated when the event occurs but the event is considered to be part of the normal
operating of the process, or of the electronics, or of the sensor.
English