Burkert Flowave 8098, Operating Instructions Manual

Page: 237 / 354

237
SAW sensor – Parameter
Type 8098 FLOWave L
Is the event associated to the device
status
Out of specification
?
Yes
• The device status indicator is yellow.
• The analogue outputs react
depending on the behaviour chosen
for Out of specification events.
• If a digital output is configured as
an on/off output to switch on Out
of specification events, the on/off
output switches depending on the
event.
Is the event associated to the device
status Maintenance required ?
Yes
• The device status indicator is blue.
• The analogue outputs react
depending on the behaviour chosen
for Maintenance required events.
• If a digital output is configured as an
on/off output to switch on Mainte-
nance required events, the on/off
output switches depending on the
event.
... continued from the previous page.
No
Fig. 66: Flowchart: operating of the diagnostics when a special event occurs (part 2/2)
15.14.1 Enabling the diagnostics for special events in the process
By default, all the diagnostics related to the process are disabled.
To enable the diagnostics of a special event related to the process, do the following:
→
Go to the
CONFIGURATION
view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Diag events
→
Process
→
Choose the special event Choose whether the information related to the special
event is a Failure , an Out of specification , a Maintenance required or a Normal state
→
Save.
The diagnostics on the special event is enabled.
→
To be informed that an event occurs, activate all the diagnostics on the device. See chapter 12.10 .
English