13
Installation
Type ME64
7
insTallaTiOn
Warning
Risk of injury due to improper installation.
▶
Only trained technicians may perform installation work.
▶
Perform installation work using suitable tools only.
7.1
Installing the device
The device will be delivered fully installed. Modifications to the device are only permitted to be
carried out by Bürkert.
→
Install the device on a level surface using 2 screws (M4) and 2 flat washers (according to DIN 125).
Observe the maximum tightening torque of 1 Nm.
→
Earth the device via the earthing lead. The earthing lead is located at the lower device attachment.
Caution
Malfunction due to electrostatic discharge.
Electrostatic discharge on the device may cause malfunctions.
▶
Connect the device to the functional earth.
Danger due to electro-magnetic fields.
If the functional earth (FE) is not connected, this represents an infringement of the legal regulations of
EMC.
▶
Connect the device to the functional earth.
▶
If the installation surface is not grounded, use an earthing strap or FE line. Connect the earthing strap or
the FE line to the earthing lead of the device attachment.
7.2
Opening or closing the side panel
→
To open or close the side panel, unfasten or fasten both screws using a cross-tip screwdriver.
nOte
Guarantee the degree of protection when screwing on the cover.
▶
Ensure that the seal is correctly fitted.
▶
When screwing on the cover, observe a maximum tightening torque of 0.4 Nm.
English
