Burkert 8026, Quick Start Manual

Page: 15 / 100

15
Installation and wiring
Programme the K factor (see § 10.5) or determine it using
→
Teach-in
Electrical wiring 8.3.
DANGER
Risk of injury due to electrical discharge.
Shut down and isolate the electrical power source before carrying •
out work on the system.
Observe all applicable accident protection and safety regulations
•
for electrical equipment.
Use a high quality electrical power supply (filtered •
and regulated).
Guarantee the equipotentiality of the installation. •
Use shielded cable. •
Electrical wiring 8.3.1.
Number of fixed connec-
tors: Type of cable plug
1 M12 male fixed connector M12 female, 5 pins (not delivered)
1 M12 male fixed connector
+ 1 M12 female fixed con-
nector M12 female, 5 pins + M12 male, 5
pins (not delivered)
Correct In cor rect
Fig. 8.5 The oval gear axes must be horizontal (seen from the front)
Fit the display module to be able to programme the transmitter
→
Refer to the instruction manual of the display module (order
code 560331, delivered with the display module) for the
mounting and dismounting instructions.
Install electronic module SE36 on fitting S070 (transmitter
→
8076) (see figure 8.6 below)
3%
3
1: Inserting the electronic module into
→
the fitting holder.
2: Turn the electronic module by a
→
quarter turn.
Fig. 8.6 Assembly of the SE36 on an S070 fitting
english
Type 8026 - 8036 - 8076