Burkert 8026, Quick Start Manual

Page: 14 / 100

14
Installation and wiring
Fit the display module to be able to programme the transmitter
→
Refer to the instruction manual of the display module (order
code 560331, delivered with the display module) for the
mounting and dismounting instructions.
Assemble electronic module SE36 and S030 fitting (transmit-
→
ter 8036) (see figure 8.3 below) or install transmitter 8026 into
S020 fitting (see figure 8.4 opposite)
3%
3
1: Inserting the electronic module into
→
the fitting holder.
2: Turn the electronic module by a
→
quarter turn.
3: Secure the electronic module and
→
the S030 fitting, by tightening the
screw with a suitable tool to a max.
tightening torque of 1 Nm.
Fig. 8.3 Assembly of the SE36 on an S030 fitting
!
"
Check that there is a seal on the
→
fitting and that it is not damaged.
Replace the seal if necessary.
Place nut A on the fitting and insert
→
circlip B into the groove.
Carefully insert the transmitter into
→
the fitting. If assembly is correct, the
transmitter can no longer rotate on
itself.
Secure the unit with nut A, tighten-
→
ing only by hand.
Fig. 8.4 Install transmitter 8026 into S020 fitting
Programme the K factor (see § 10.5) or determine it using
→
Teach-in
Recommendations on installing an 8.2.2.
8076 on a pipe
Install the S070 fitting on the pipe in such a way that the oval gear
→
axes are in the horizontal plane, as shown in Fig. 8.5.
english
Type 8026 - 8036 - 8076