Plus-X 600 Installation and Operation Manual Rev B
7
If desired, you may manually map Plus-X 600 channels to ARC Plus channels in AutoLoad Plus
by selecting the
Meter Channels, Status Channels
or
Commands
tab, as appropriate:
Within any of these tabs, click the
Source
button to configure a channel to use a Plus-X
device channel as its source.
When the Source dialog appears, select
Plus-X channel
and choose the Plus-X device
from the list.
Select the Plus-X 600 channel you wish to use.
Click
OK
.
Once mapped, each Plus-X 600 channel will appear on the front panel of the ARC Plus, in
AutoPilot, on the ARC Plus web page, and will be accessible via the ESI.
Uploading New Firmware
You can load new firmware to the Plus-X 600 using its onboard web interface. Navigate to the
IP address of the Plus-X 600, log on, navigate to the
Settings
page and click the
Upload
Firmware
link. Click the
Browse
button to select the firmware file, then click
Upload
to load the
new firmware. The Plus-X 600 will reboot after the firmware upload is complete.
Uploading Firmware to the Plus-X 600
For the latest firmware updates, visit www.burk.com.
