Juice Box Stage 3 Professional (Pin out) Installation Guide – 5/13/09
JB3 Pin Out Installation Guide
© 2009 Copyright Burger Motor Sports, LLC
1 / 9
JB3 professional/pin-out is intended for experienced enthusiasts only. If this is your first
install please have someone on hand who has performed an install before. You can also
review the install video on our website ahead of time to prepare.
The directions in this guide supersede the install video. Use the video for reference but follow
this guide.
1) Lock and close doors and trunk, and wait 10 minutes for the ECU to go to sleep. If you
have comfort access place keys inside the house to avoid waking up ECU. Alternatively you
may disconnect the negative battery terminal. Do not open the doors or unlock the car while
the ECU connectors or JB3 control box are unplugged.
2) If you have a tuner installed (e.g. JB2) remove it.
Be sure to also return the solenoid
vacuum lines to stock.
If equipped with a downpipe fix or sim ensure the black wire
(ground) is in the #23 spot on the small black subconnector and not shared with the JB3.
3) Access the ECU area using the Stage 1 / Stage 2 install guide and remove both the left and
right ECU connectors. Slide each of the subconnectors out one by one as you install the JB3
harness wires as indicated below. The small ECU connector requires you to remove the slider
per the Stage 1 / Stage 2 install guide to access the small black and grey subconnectors.
Summary of Contents for 135
Page 1: ......
