PointSafe
English
|
2
Dear customer,
Thank you for buying a safe belonging to the Point Safe family. This safe was
developed and manufactured by Burg-Wächter using the latest technical
features. This Point Safe has been designed to be used in both standard and
hotel modes. In addition to the keypad this safe comes with mechanical
emergency override key.
We hope you enjoy your new BurG-WächTer safe.
Important: Please read the entire User Manual before
you start programming.
Important Notes
– Store your codes and emergency Override key at a secure location
and Not inside the safe (the emergency lock is located under
the 4 batteries).
– For security reasons we recommend you do
Not
use personal numbers
for example D.O.B and Telephone numbers as your user or Master code.
– If the safe is not going to be used for a prolonged period of time,
please remove the batteries.
– For hotel mode: See “
Point Safe in hotel mode
” and the attached
guest code instructions.
– For security reasons, Both the user and administrator codes should be
changed from there factory settings.
– This Point safe will only reach its required security level if correctly
bolt fixed to a secure wall or floor.
(Please use the provided anchoring bolts)
– For security reasons, the user code should be different from
the Master code.
– Please contact your vendor if you have any questions or problems
regarding your Burg Wachter Point Safe.
General
The Point series safes can be operated both standard mode and a hotel
mode. In both of these modes, a Master code and a user code are available
to operate the safe.
The Master code must have 8 digits.
The user code can have between 3 and 6 digits.
Master Code:
12345678 (factory set)
User Code:
168 (factory set)
Technical data
Blocking times
After 3 wrong code entries for 5 minutes
Power supply
4 x MIGNON Lr6 / AA / ALKALINe
Working
temperature
conditions
–15 °c to +50 °c
up to 95 % rel. air humidity
(noncondensing)
Setting up PointSafe
– remove the screw from the battery compartment side.
– Move the front cover cap with the PointSafe logo to the right.
– Insert the batteries (4 pieces, Lr6 / AA / 1.5V / Alkaline).
– The electronics will need approx. 30 sec. to load the program.
Then press the “enter” button.
– enter the user code (168).
– Press the “enter” button again.
Now the safe can be opened and individually programmed.
Attention:
If the batteries are too low, “Lo Batt” appears on the display.
All 4
batteries need to be replaced in such case (Lr6 / AA / 1.5V / Alkaline).
Structure
Illustrations
Enter
Close / Clear
Set
Time
H/M
