Burda BRELG1200, Instructions For Use Manual, Page: 19 / 72

19
CAUTION: There is a built in safety feature that will automatically trigger the heater to go into standby mode after
eight hours of continuous operation. At this time the lowest heat temperature setting LED will be flashing to indicate
the safety feature has executed.
4. Timer function:
Press the button of hour zone of remote control (Picture 10), the delay-off timer (1 hour, 2 hours or 3 hours) can be
activated.
4.1 Point the remote control directly to the receiver and press the button of “1”, a single green LED will illuminate
directly beside the power LED’s, this will trigger the heater to automatically go into STANDBY mode after 1 hour (60
minutes) of operation. Once in STANDBY mode a single red LED will be flashing.
4.2 Point the remote control directly to the receiver and press the button of “2”, a single green LED light will illuminate
with a gap between the heat and timer LED’s on the unit, this will trigger the heater to automatically go into STANDBY
mode after 2 hours (120 minutes) of operation. Once in STANDBY mode a single red LED will be flashing.
4.3 Point the remote control directly to the receiver and press the button of “1” and “2”, both green LED lights will
illuminate, this will trigger the heater to automatically go into STANDBY mode after 3 hours (180 minutes) of
operation. Once in STANDBY mode a single red LED will be flashing.
INSTALLATION
Before installation, read the manual carefully.
The heater must be installed in accordance with the manufacturer’s installation instructions
This heater comes with a pair of stainless steel adjustable angle mounting brackets. The adjustable angle enables the
heater to be installed on vertical, horizontal and inclined surfaces.
picture 11: 1 hour timer
picture 10
picture 12 : 2 hours timer
picture 13 : 3 hours timer