3.8 RELAYS
1. Remove cover plate from rear terminal box.
2.
Undo electrical connections from relay and remove fixings.
3. Replace in reverse order. Electrical connections to be restored as detailed in wiring
diagram.
3.9 CONTROL FUSE
The control fuse is located within rear terminal box.
3.10 THERMAL CUTOUT
A thermal cutout is fitted to oven chamber back panel. Access is through outer back panel
cover plate.
To reset, press button in centre of cutout.
To remove, undo bracket fixings. Replace in reverse order.
WARNING: IF THE THERMAL CUTOUT HAS TRIPPED, THE REASON FOR
OVERHEATING MUST BE IDENTIFIED AND REMEDIED BEFORE PUTTING THE UNIT
BACK INTO SERVICE.
Note:
If space is restricted at rear of unit, overheat safety trip may be accessed through
the oven compartment by removal of fan support panel. Slacken top and bottom fixings
of fan baffle and tilt baffle forward to remove. Undo fan support panel fixings and fold
sideways. Take care not to strain electrical wiring.
3.7 FAULT CHECK LIST
If a flame is not established on any hotplate burner, follow this check list:
1. Check mains gas is ON.
2.
Check pressure at pressure test point to ensure gas is flowing to the appliance.
3. If gas is present then check burner injector for blockage.
4. If injector is clear then check FFD magnet unit is engaging and allowing gas to pass.
5.
If a flame is still not present then re-check from start.
If a flame is established but not maintained then follow this check list:
1. Check thermocouple sensor is secured correctly and that burner ports are clean.
2.
Check that thermocouple is not damaged and is securely fixed to FFD section of gas
control.
3.
Check FFD is energising and maintaining flame.
4.
If after carrying out the above, the burner is still not maintaining the flame then check
magnet unit within control.
SECTION 4 - SPARES
When ordering spare parts, always quote the appliance type and serial number.
This information will be found on the data badge attached on the rear of the product.
