3.1.5 Cleaning
Burners should be cleaned periodically to maintain maximum performance. Open top
burners should be cleaned as detailed in User Instructions.
3.2 INJECTORS
3.2.1 Hotplate
1. Remove burner caps and skirts.
2. Undo and carefully remove injector.
3. Replace in reverse order.
3.3 THERMOCOUPLES AND FLAME FAILURE DEVICE (FFD)
3.3.1 Hotplate flame failure device magnet unit
1. Undo thermocouple at FFD section of gas tap.
2. Undo FFD section cap at rear of gas tap and withdraw magnet unit and replace in
reverse order.
3.3.2 Hotplate thermocouple
1. Remove hotplate as detailed in Section 3.1.2.
2. Remove nut securing thermocouple sensor to burner support bracket and pull
thermocouple through support bracket from underside.
3. Undo thermocouple connection at FFD section of gas tap and carefully remove
thermocouple.
4. Replace in reverse order, take care not to overtighten thermocouple.
3.4 OVEN THERMOSTAT
Thermostat calibration:
The thermostat does not require calibration. If centre oven
temperature is outside specified tolerances then replace thermostat and return faulty
thermostat to the Customer Care Centre.
1. Remove control knobs and facia panel as detailed in Section 3.1.1.
2. Remove hotplate as detailed in Section 3.1.2.
3. From inside the oven, note the route/location of the thermostat capillary/phial.
4. Gently pull the thermostat phial free from the left clip. Slide the phial to the left to free
the phial’s clenched end from the right clip’s locator hole.
5. Carefully feed capillary and phial through the oven top panel’s hole.
6.
Undo fixings which secure thermostat to fascia panel, separate selector switch from
thermostat by pulling apart.
7. Replace all parts in reverse order.
3.5 GAS TAPS
Note:
Plugs and bodies are machined in pairs and are therefore not interchangeable.
Always clean one tap at a time.
1. Remove control knobs and facia panel as detailed in Section 3.1.1.
2. Remove hotplate as detailed in Section 3.1.2.
3. Undo thermocouple connection at FFD section of gas tap. Undo burner supply pipe at
gas tap rear.
4.
Undo fixings which secure tap to gas rail.
5. Replace all parts in reverse order, renewing o-ring seal if necessary. Take care not to
overtighten thermocouple connection at gas tap rear.
3.6 NEON INDICATORS
1. Remove control knobs and facia panel as detailed in section 3.1.1.
2. Disconnect wires from indicator.
3. Remove indicator from panel and withdraw.
4. Replace in reverse order.
3.7 OVEN ELEMENTS
1.
Remove shelves and back baffle.
2.
Undo element fixing screw and withdraw into oven.
