INTRODUCTION
.
To ensure you obtain full benefits from your new oven:
• Please read this instruction booklet carefully, and follow all instructions.
• If you are unsure of any aspect of the installation, use or performance of your oven,
please contact the after sales number shown on the back page
.
SPECIFICATIONS
Model No.
BC 1/1 GN 3.0 kW
Convection Oven
BC 1/1 GN 6.0 kW
Convection Oven
HW
Dimensions
Height
753mm
753mm
Width
670mm
670mm
Depth
662mm
662mm
Weight
51kg
52kg
Voltage
240V
240V
Power Rating
3070W
6070W
Water Pressure
0.2 - 0.8MPa
WARNING:
Do not open drain cocks or other emptying devices until the pressure has been re
-
duced to approximately atmospheric pressure. symbol 5021 of IEC 60417-1 is marked on the ap
-
pliance its meaning shall be explained.
WARNING:
To avoid scalding, do not use loaded containers with liquids or cooking goods which
becomes fluid by heating in higher levels than those which can be easily observed.
WARNING:
Extreme caution must be used when moving this unit as it is VERY HEAVY
WARNING:
Metal surfaces may become very hot whilst in operation. Use caution when touching
these surfaces.
Caution:
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appli
-
ance must not be supplied through an external switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by the utility.
Caution
: Where this appliance is to be positioned in close proximity to a wall, partitions, kitchen
furniture, decorative finishes, etc., it is recommended that they be made of non-combustible mate
-
rial, or if not, that they shall be clad with a suitable non-combustible heat-insulating material, and
that the closest attention be paid to fire prevention regulations.
INSTALLATION
Installation Requirements
I
t is essential that this appliance is installed correctly. Installation should comply with all local
electrical, and health and safety requirements.
WEEE directive registration no. WEE/CK0046SY/PRO
At end of unit life, dispose of appliance and any replacement parts in a safe manner,
via a licenced waste handler. Units are designed to be dismantled easily and recycling
of all material is encouraged whenever practicable.
