4
150143
(4 tubes)
/ 150152
(3 tubes)
HEAT SHRINK SPLICING KIT
SHRINKING TECHNIQUE
Insert one wire end into wire connector and crimp it.
Insert the second wire end into wire connector and crimp it.
Set the connector in the middle of the tube.
Shrinking can be accomplished through the use of a thermo
gun or flame torch with a utility head or other broad flame.
Begin at one end of tubing. Keep tubing out of direct contact
with flame. Keep flame moving back and forth.
Progress toward other end as tubing shrinks and wrinkles
disappear. Keep the flame moving. A small amount of glue
should be visible around the ends of the tube.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
Shrinking can be accomplished through the use of a thermo gun or flame torch with a utility
head or other broad flame. Begin at one end of tubing. Keep tubing out of direct contact with
flame. Keep flame moving back and forth. Progress toward other end as tubing shrinks and
wrinkles disappear. Keep the flame moving. To prevent electric shock, make sure that the
power supply is disconnected.
Strip approximatively 1/4’’ (6mm) of wire insulation from both end of wires to connect. Clean
wires about 3’’ from ends and put tube over one end.
Allow the tube to cool before installing the pump.
Put together all spliced wires and use electrical tape to cover the complete heat shrink from
beginning to end.
1
2
5
3
4