10
trifecta
®
MB coffee and tea Brewer
INdICATOR LIGhTS
SUGGESTIONS
Brew Button Light and
Reservoir Light flash (alternate
flashing)
• Brewer is in initial setup mode and must be primed
with water. See Setting Up trifecta on page 3.
Brew Button slowly flashes
• Water in the brewer is not up to proper temperature
yet. Wait for the water to heat – the Brew Button will
illuminate solid blue when ready.
Brew Button is lit (steady glow)
• Water is hot and trifecta is ready to brew.
Reservoir Light flashes 4 times
after pushing Brew Button
• The Brew Chamber is missing, Latch is not closed or
Latch has not been opened and closed since last
brew cycle.
• Open Latch, remove Brew Chamber, replace Brew
Chamber, close Latch and press the Brew Button
again.
Reservoir Light flashes rapidly
after pushing Brew Button
• Add water. A minimum of 6 ounces of water is
required.
Brew Button flashes quickly
• Brew was interrupted by lifting the Latch or pushing
the Brew Button. The button will continue to flash
until you push the Brew Button again. Push the Brew
Button again and (after a brief pause) the brewer will
push out the contents of the Brew Chamber. Note:
Make sure that a cup is positioned on the Drip Tray un-
der the Brew Chamber prior to pushing Brew Button.
trifecta Mb is equipped with a system for displaying helpful feedback. the brew button
Light in conjunction with the Reservoir Light provides valuable feedback or can help you
troubleshoot.
INdICATOR LIGhT REFERENCE
to avoid dropping and damaging the brewer, always grasp the brewer by the sides and
bottom, or top and bottom of the brewer.
Unplug the brewer and wait for it to cool. brewer must be stored upright and above
32°f/ 0°C to prevent damage to the Stainless Steel Hot water tank. If you do not use
trifecta for an extended period of time, we recommend running two or three cycles of
water through the brewer prior to brewing coffee or tea.
STORING ThE BREWER
IMpORTANT hANdLING INFORMATION
