5
•
Use CAUTION when dispensing hot water from the brewer. The water from your
BUNN
®
Pod brewer is approximately 200°F (93°C). This is approximately 50°F (10°C)
hotter than the hot water from your faucet and must be handled with care.
• This brewer is designed to remain plugged in at all times (except during initial
installation, cleaning, or when brewer will not be used for an extended period of time).
• A power switch is provided on the lower left side to completely shut off all electrical
components when your plans take you away from the brewer for three or more days.
Safety features, designed into the BUNN
®
Pod brewer, make the daily use of this switch
unnecessary.
• Whenever the brewer has been shut off or unplugged for an extended period of time,
rinse the reservoir and refill with fresh cold water before using. It is also recommended
that the brewer be cycled. (See page 18)
• Your BUNN
®
Pod brewer has a specially designed tank to keep the water inside at the
proper temperature. This constant supply of hot water assures the correct method of
brewing in less than one minute.
• When inserting a pod into the pod holder, it is important to seat the pod all the way into
the holder cavity. Leaks could occur if the pod is too large, or does not seat completely
into the holder cavity. Ensure that all of the paper edge and any tabs of the pod are
inserted into the holder cavity.
• While brewing, the newest water in the tank is also being heated to the proper
temperature and held until needed.
• The brewer is equipped with a 120 volt, 3-prong grounded cord set. The plug is provided
with a round grounding pin. This is a safety feature and allows the plug to fit into a
properly grounded outlet. If the plug does not fit into the outlet, contact an electrician
to update your outlet. Attempting to bypass the safety aspect of this plug will void the
warranty.
• The sprayhead may become loose over time. Unplug the machine and allow it to cool
down before tightening or removing the sprayhead. Use extreme caution not to burn
yourself. Tighten or remove the sprayhead with your fingertips. (Refer to page 17)
•
CAUTION:
Never apply force to remove the pod holder. If the holder does not slide out
easily, wait 10 minutes and try again. Burns resulting from hot water splash could occur
if the holder is forcibly removed from the brewer.
• Use
CAUTION
to avoid burns during consumption of any freshly brewed beverage.
Servings are extremely hot.
• To stop a brew cycle in process, press the Coffee or Tea button again. (See “Brew
Cancel” on Page 8)
• When operating the brewer on a standard household outlet, do not attempt to power
other appliances on the same circuit. Circuit overload could occur.
GENERAL INFORMATION
Improper installation could result in permanent damage and void the
limited warranty. Read & follow instructions on page 9 or 10.
