background image

3

USER NOTICES

 

Carefully read and follow all notices on the grinder and in this manual.  They were written for your protection. All notices 

on the grinder are to be kept in good condition.  Replace any unreadable or damaged labels.

#34891.0000

20545-0000D  01/04  © 1990  Bunn-O-Matic Corporation 

READ THE ENTIRE OPERATING MANUAL 

INCLUDING THE LIMIT OF WARRANTY AND 

LIABILITY BEFORE BUYING OR USING THIS PRODUCT 

An extension cord, when used, must be shorter 

than 20 feet if 16-gage 3-conductor wire, or 

shorter than 10 feet if 18-gage 3-conductor wire. 

FAILURE TO COMPLY RISKS EQUIPMENT 

DAMAGE, FIRE, OR SHOCK HAZARD 

Use only on a properly protected circuit 

capable of the rated load. 

Electrically ground the chassis. 

Follow national/local electrical codes. 

Do not use near combustibles. 

WARNING 

#20545.0000

CONTENTS

 Introduction ..................................................................... 3

 

User Notices ..................................................................... 3

 

Electrical Requirements.................................................... 4

 

CE Requirements.............................................................. 4

 

Operating Controls ........................................................... 4

 

Initial Set-Up .................................................................... 5

 Cleaning ........................................................................... 5

 

Preventive Maintenance ................................................... 5

 

Coffee Grinding ................................................................ 6

 Adjustments ..................................................................... 7

INTRODUCTION

 

This equipment will store up-to six pounds of whole bean coffee in each of two hoppers and grind it to a preset grind 

and amount into an awaiting funnel and filter from most commercial drip coffee brewers.  The equipment is only for indoor 

use on a sturdy counter or shelf.  Adequate space must be available above the grinder to raise the lids when adding beans.  

Use only with whole bean coffee.

The grind is preset at the factory to drip specifications as set forth by the United States Department of Commerce and 

adopted by the Coffee Brewing Center of the Pan American Coffee Bureau.  Adjustments may be made to alter both the 

amount and grind from the factory setting.

KEEP FINGERS AND

FOREIGN OBJECTS

OUT OF HOPPER

OR CHUTE OPENING.

PERSONAL INJURY

HAZARD.

#05876.0000

10218 070913

#37881.0000

00824.0002

HAZARDOUS

VOLTAGE

DISCONNECT  FROM

POWER  SOURCE

BEFORE  REMOVING!

Summary of Contents for G9-2 HD









Reviews: