AXIOM
®
RFID Training
8
Mechanical
RFID Board
The board is located in the hood assembly on the right-hand side. The board contains the TIC clock. Three connec-
tors are represented at the top of the RFID board, where the RFID coil/sensors are connected. The three connectors
are labeled and identified above the connector.
Warmer Sensor
1. Top Front (J7-1)
2. Main (J6-1)
3. Top Rear (J5-1)
4. TIC Clock
The RFID board operates in a range between 124.0 and 127.0 khz while writing and reading the date/time to the
RFID carafes through the use of the RFID coil/sensor. The RFID board can be monitored for frequency and tested by
a test menu in programming using the left hidden button. The menu option is “Freq&AdjustCaps”.
Beeper
The Axiom brewer with RFID utilizes a beeper along with the freshness
indicator LED sequence. Two beeper alarms are represented within the
operation of the unit with the capability of adjusting the volume and
activation of the audible alarms.
• The expiration alarm will sound an audible beep when the coffee
freshness time has expired or when the flashing red LED is visible.
The alarm will beep once every ten seconds.
• The pre-expiration alarm will sound an audible beep when the coffee
freshness time had reached the remaining five minutes or when the
flashing yellow LED is visible. The pre-expire alarm will beep once a
minute before the expiration alarm.
The beeper harness and lock nut can be accessed through the front panel and the beeper is removed from the top or
hood assembly.
RFID Coil/Sensor
A RFID sensor is represented by each warmer plate. The
sensor picks up the recorded brew date/time from the RFID
carafe and will show it on the display. All of the sensors can
be checked for operation by utilizing the test menus that are
accessed by using the left hidden button. The menus are ab-
breviated on the display.
• M = Main
• TF = Top Front
• TR = Top Rear
If a box appears to the right of the abbreviation while a RFID carafe is on the
corresponding warmer plate, this indicates that the sensor or circuit is operating.
The block will disappear when the RFID carafe is removed from the warmer plate.
Beeper
1
2
3
4
