Bunn Axiom Series Technical Training Manual Download Page 7

Bunn-O-Matic Corporation

7

 

Press “+” or “-” to adjust the hour.

Press “+” or “-” to adjust the minutes.

 

  Press “+” or “-” to adjust the seconds.

  Enable/disable the 5 minute warning beep sequence for a carafe that’s about to expire.

  Sequence: The last 5 minutes of the freshness time remaining message or the 

  corresponding warmer flashing yellow LED; the pre-expire alarm will beep once a  

  minute with a total of 5 beeps before the every 10 second expiration alarm takes over.

Digital 3-Click Brew Volume Setup

The digital 3-click volume setup is added for the convenience of setting pot levels. The segment of adding or sub-

tracting an ounce of water during setup is not possible. This method of calibrating pot levels is more user friendly to 

the operator than entering the programming menus using the right hidden switch and then making the volume adjust-

ment.

 

  Note: The brew oz. volume will automatically change on this screen when you perform  

  the optional 3-click brew volume setup. If the program lockout switch is in the lock 

  position on the control board, while performing the 3-click volume setup procedure, the  

  new calibration time or volume will not hold and will go back to the original setting. You  

  have the perception of calibrating a new volume without any warning of the lockout  

 

 

 

 

switch being locked.

Freshness Indicator LED Color Sequence

The freshness time remaining message will operate in conjunction with the warmer element LED color sequence.

Green LED

The green color means you are within the freshness time limit (0.5 hrs/glass).

Flashing Yellow LED

The yellow color is a warning indicator, which tells the operator that the glass freshness time is about to expire. The 

LED will change from green to yellow when the freshness time reaches the last five minutes of the freshness time 

limit (0.5 hrs/glass).

Flashing Red LED

The red color means that the freshness time has expired and the warmer element is about to turn off automatically.

Note: When the “Freshness Expired” message or the flashing red LED appears, the warmer will turn off automatically 

after five minutes.

Summary of Contents for Axiom Series










Reviews: