Page 2
For technical questions, please call 1-888-866-5797.
Item 64910
Specifications
Electrical Rating
120VAC / 60Hz / 32W
Motion Detection
240° @ 20 ft.
90° @ 69 ft.
IMPORTANT SAFETY INFORMATION
TO PREVENT SERIOUS INJURY AND DEATH FROM ELECTRIC SHOCK: THIS PRODUCT MUST BE
INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
Before you begin installing, servicing, or maintenance of this product follow these general precautions:
1. To reduce the risk of death, personal injury, or
property damage from fire, electrical shock,
falling parts, cuts/abrasions, and other hazards
please read all warnings and instructions included
with and on this product prior to installation.
2. For commercial installation: Service and
maintenance of this product must be performed
by a qualified, licensed electrician.
3. For residential installation: If you are unsure
about the installation or maintenance of this
product, consult a qualified, licensed electrician.
4. Do not mount against flammable surfaces.
5. This product is intended to be used outdoors,
and be subject to the elements; such as
rain and snow and we recommend it to be
mounted at least 6′ 6″ off the ground.
6. This LED product must be powered
directly to a switched circuit.
7. Make sure that where this fixture will be
mounted is structurally sound and that it
will support the weight of this fixture.
8. This product should not be used in areas with
limited ventilation or high ambient temperatures.
9. This product is intended to be connected to a properly
installed and grounded UL listed junction box.
WARNING! RISK OF ELECTRICAL SHOCK
1. Turn off electrical power at the fuse or circuit breaker
box before wiring this product to the power supply.
2. Verify voltage is 120V before installing.
3. All wiring connections should be capped
with UL listed wire connectors.
CAUTION! RISK OF PRODUCT DAMAGE
1. Never connect fixture with power on.
2. Do not mount or support product in a
manner that can cut the outer wire jacket
or damage the wire insulation.
3. Avoid covering LED products with insulation,
foam, or other materials that will prevent
convection or conduction cooling.
4. Never connect an LED product directly to dimmer
packs, occupancy sensors, timing devices, or other
related control devices, unless individual product
5. LED products are polarity sensitive, ensure
proper polarity before installation.
6. Electrostatic Discharge (ESD) can cause damage to
LED products. Wear personal grounding equipment
during installation and service of the product.
7. Do not touch the individual electronic components,
it may cause ESD (Electronic Discharge),
shorten lamp life or alter performance.
