Page 11
For technical questions, please call 1-888-866-5797.
Item 61624
SAFET
y
ADV
ANCED
MAINTENANCE
TROUBLESHOOTING
OPERA
TION
SETUP
BASIC
E. Mount Cameras
CONNECT AND TEST ALL EQUIPMENT AND CAMERA LOCATIONS
BEFORE MOUNTING CAMERAS.
Mount Cameras under eaves. Place
Cable Connections inside walls to shelter
them from rain and direct sunlight.
Using the Base as a template, mark locations
of mounting holes on mounting surface.
Note:
Route Cable through slot on Base to keep Base
flush with mounting surface while marking holes.
Solid Surface
1. Using a drill bit slightly smaller than the Screws,
drill pilot holes into the marked locations.
2. Position Camera so that mounting
holes align with pilot holes.
Note:
Route Cable through slot on Base to
keep Base flush with mounting surface.
3. Drive Screws through mounting holes in
Base and into pilot holes until the Camera is
securely attached to the mounting surface.
Hollow Surface
1. Using a drill bit slightly smaller than the
Anchors, drill holes in the marked locations.
2. Tap Anchors into the holes until they are
almost flush with mounting surface.
3. Position Camera so that mounting
holes align with anchors.
Note:
Route Cable through slot on Base to
keep Base flush with mounting surface.
4. Drive Screws through mounting holes in
Base and into anchors until the Camera is
securely attached to the mounting surface.
Camera Adjustment
1. Loosen Adjustment Wheel, rotate Camera as
needed, then tighten Adjustment Wheel.
2. Loosen Adjustment Screw, tilt Camera as
needed, then tighten Adjustment Screw.
Note:
Only loosen Adjustment Screw
slightly, do not remove it.
Adjustment
Wheel
Adjustment
Screw
F. Set Date and Time
Note:
Use Mouse to navigate the DVR.
1. Right click on screen,
click System Setup.
2. Click Time.
3. Put cursor in Date box,
click keys to set date.
4. Put cursor in Time box,
click keys to set time.
5. Click OK.
Mounting
Holes
Cable
Slot
Base