EXP3040-manual-en
Page 5 / 8
The thickness of the workpieces to be processed should not exceed 5 mm, otherwise a functional impair-
ment of the vacuum, or even damage to the vacuum foil may result. For this reason, no sharp objects be-
tween the glass plate and the vacuum film may be on the glass table, when the vacuum is turned on. Also
make sure that the vacuum hose is not blocked by obstacles.
Operation safety
Do not stare into the UV lamps! Intended use is carried out in a closed state, in order to avoid eye injuries.
Lift the lid only to place artwork (prevent lid from falling)
Do not drop machine
Environment
Attention: LED lamps must be handled carefully and disposed of in accordance with the rules of haz-
ardous waste.
Set Up
The machine is supplied in a special
wood packing. Check the condition of
packing immediately at reception.
Goods delivered by a carrier and signed
as "Received in good condition" will be
impossible to be returned as "Damaged
in transit". If you recognize any damage
after unpacking you need to declare this
transport damage to the shipping agent
immediately in written and verbal. In this
case please also notify us.
To unpack, remove the lateral wood
package. Due to the weight and danger
of damage do not just roll the unit off the
pallet. Use a fork lift to take the unit off
the pallet and place it on even ground.
From then on the machine may be
moved on it's rollers.
The installation location of the machine
is of special importance. You should
choose a mostly dust free room with a
non corrosive atmosphere. The floor
should be flat and straight. Place the
machine in some distance to the wall
so you always have access to the rear
and the lower exposure level.
To check that the electrical compo-
nents of the unit work correctly, please
follow the operating instructions given
here below. The set requires a 230 V,
50 Hz main supply.
After connecting the machine to
buildings power supply you can turn
on the red main switch
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]
