How to check the operation condition during operation
(1) Pressing DISPLAY/SCAN switch, display appears in the following sequence:
*** ROOM CONDITION ***
16.5℃
37%RH
room temperature and humidity
** SET POINT(CPA) **
24.0℃
55%RH
desired temperature and humidity
** SET POINT(PB) **
3.0 degC
10%RH
desired proportion belt(PB)
** SET POINT(DB) **
1.0 degC
5%RH
desired desensitized belt(DB)
** OUTPUT STATUS ***
INDOOR FAN ON/OFF
fan output
** OUTPUT STATUS ***
E - HEAT 1 : ON/OFF
heater 1 output
** OUTPUT STATUS ***
E - HEAT 2 : ON/OFF
heater 2 output
** OUTPUT STATUS ***
E - HEAT 3 : ON/OFF
heater 3 output
** OUTPUT STATUS ***
COMPRESS 1 : ON/OFF
compressor 1 output
** OUTPUT STATUS ***
COMPRESS 2 : ON/OFF
compressor 2 output
** OUTPUT STATUS ***
COMPRESS 3 : ON/OFF
compressor 3 output
** OUTPUT STATUS ***
HUMI HEAT 1 : ON/OFF
humidify 1 output
** OUTPUT STATUS ***
HUMI HEAT 2 : ON/OFF
humidify 2 output
** OUTPUT STATUS ***
WATER S-V/V : ON/OFF
water solenoid valve output
(2) Pressing DISPLAY/SCAN switch, display appears in the following sequence:
*** System Start ***
MODE = auto humi/temp
*** System Start ***
Local Start Running
* OUTPUT CONDITION *
Heating = N STEP
Summary of Contents for 200J
Page 10: ...Name of parts UCU 30M 50M 80M 100M UCU 150J 200J ...
Page 20: ...How to use controller ...
Page 23: ...Main Control Part ...
