6
5. Pull the A-pillar down to
access the screws that secure
the grab handle.
6. Remove the two
grab handle screws.
(Use a Phillips screwdriver.)
a. The grab handle will separate from the A-pillar.
b. Set the grab handle and screws aside.
7. Push the stock A-pillar back into its original location.
a. Secure it with the plastic clips (step 4).
8. Attach the GT, WatchDog or PMT to the custom pod.
(See diagrams on pages 3
and 4.)
9. Slide the custom pod onto the
stock A-pillar so that it sits just
below where the handle would
fit.
10. Replace the grab handle.
(Secure it using the stock 8
mm bolts.)
11. Replace the side panel
and re-secure the weather
stripping.
Position
Reattach Handle
Pull Back Stock Pillar
