8
WIRING DIAGRAMS
8
7
6
5
4
3
2
1
16 15 14 13 12 11
9
BLUE
:
WHITE
:
MAIN CONNECTOR
HOW TO USE
YOUR REMOTE TRANSMITTER
Arming
Press Button #1 to arm the system. The siren will
chirp 1 time, the lights will flash once, the power
door locks will lock (if installed), and the LED
will flash slowly indicating the alarm is now armed.
The engine starter is also disabled.
Disarming
Pressing Button #1 again will disarm the system.
The siren will chirp twice, the lights will flash
twice, and stay illuminated for 30 seconds,
acknowledging that the system is disarmed. NOTE:
If you hear 3 siren chirps and see 3 light flashes
when disarming, the vehicle was violated while you
were away. Check the LED for zone violation. See
Operating Instructions, page 18 for “Violated Zone”
explanation. This is a good time to check your
vehicle for possible damage. When disarming, the
dome light will turn on for 30 seconds if the Dome
Light Supervision feature is connected (optional,
part #775 required).
Silent Arming/Disarming
Should you desire not to have the siren chirp when
arming and disarming, press and hold Button #1 for
3 seconds. The system will perform all its usual
arming/disarming functions, except there will be
no arming and disarming chirps. If the alarm is
triggered, the siren will provide its normally loud
sound. NOTE: If the lights flash 3 times after
disarming, the vehicle has been violated as described
in Operating Instructions, see page 18 for “Violated
Zone”.
Remote Car Starter (
Optional equipment required)
A second channel built into this model can be
activated while it is in the armed or disarmed mode.
The second channel can be used for remote engine starting (optional module required). Press Button #2 while
the system is armed or disarmed, the parking lights will flash once, and then will activate the installed
accessory. CAUTION: When remotely starting the vehicle while the system is armed from Button #2, shock and
current sensing will automatically shut off.
Car Finder
While the system is armed, press and release Button #3. The alarm will chirp 6 times and the parking lights
will flash. This is used to locate your vehicle in a crowded parking lot.
Optional Accessories
(Trunk Pop, etc., Opt. Part #775 required)
NOTE: When the alarm is disarmed, press Button #3 and the trunk will open. When the alarm is armed, press
and hold Button #3 for 2 seconds or until the trunk opens. If Button #3 is pressed and held, a ground output
signal is applied to the connected accessory for as long as this button is pressed. CAUTION: When opening
the trunk while the system is armed, shock and current sensing will shut off.
Instant Personal Panic
Press and release transmitter Button #4 to sound the instant panic siren. The lights and siren will activate
for 30 seconds and then shut off. To stop the siren before the 30 seconds, press any of the 4 transmitter
buttons.
FIGURE 1
1. Red
(+) 12 Volt Constant
2. Black
Chassis Ground
3. Grey
(+) Siren Output
4. White/Red
Button #3 / Channel #3 (-) Output: Window Rollup,
etc. 200 mA Max
5. White/Yellow
Button #2 / Channel #2 (-) Output: Remote Starter,
etc. 200 mA Max
6. Brown/Black
Not Used
7. Green/Black
Not Used
8. Orange
(-) Output when armed: Starter Disable
9. Brown
(+) Parking Light Output
10. Open
11. Green
(-) Shock Sensor Input (minor): Warn Away /
10 Second delay after arming
12. Yellow
(+) Shock Sensor Input (major): Triggers
Alarm / 10 Second delay after arming
13. Black/Blue
(+) Door Pin Input /
20 Second delay after arming
14. Black/Yellow
(-) Door Pin Input /
20 Second delay after arming
15. Violet
(-) output dome light
supervision 300 mA max
16. Red/Black
(+) 12 volt ignition sense input
RED
BLACK
5-Pin
Door Lock
Harness
Connector
YELLOW ANTENNA WIRE
Make sure you keep
this wire as
straight as
possible. Keep away
from any metal or
moving parts from
below the dash.
1
3
2
4
BULLDOG
BUTTON #2
OPTION #2
BUTTON #4
PANIC
BUTTON #1
ARM/DISARM
BUTTON #3
OPTION #3
BUTTON #2
OPTION #2
BUTTON #4
PANIC
BUTTON #1
ARM/DISARM
BUTTON #3
OPTION #3
BULLDOG
