4
CAUTION: All wires must be wrapped with tape and wire tied.
4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection.
Secure with wire ties as shown.
3. Lay upper twisted pair of wires over right
wire as shown. Bring lower twisted pair
of wires up to meet the left wire as
shown.
2. Twist upper wires together, twist lower
wires together as shown.
1. When tying two separate wires together at their ends, strip back one inch of insulation on
both wires and separate the strands of wire as shown below.
Use this method ONLY when connecting two separate wires end to end.
Wire Tie
Electrical Tape
Wire Tie
MAKING END TO END CONNECTIONS
Use this method ONLY when connecting two separate wires end to end.
LOCATING & MAKING CONNECTIONS
MOUNTING AND CONNECTING THE SIREN
Select a location under the vehicle's hood for the siren.
•The mounting location should be solid and have no moving parts nearby.
•For the loudest sound, the siren should point down.
•The siren should not point straight up as moisture could collect in the siren horn.
•To prevent water damage, the siren should not be mounted in a wheel well, directly behind the radiator
grill, or close to the ground.
Once you select a location, follow these steps to mount the siren:
1.Using the siren base as a template, mark the three mounting holes.
2.Drill an 1/8" hole at each mounting hole location, taking care not to damage anything behind the mounting
surface.
3.Secure the siren to the mounting location with at least two of the mounting screws.
