8
HOW TO USE YOUR REMOTE TRANSMITTER
Arming
Press Button #1 to arm the system. The siren will chirp 1 time, the lights will flash once, the power door
locks will lock (if installed), and the LED will flash slowly indicating the alarm is now armed. The engine
starter is also disabled.
Disarming
Pressing Button #1 again will disarm the system. The siren will chirp twice, the lights will flash twice,
and stay illuminated for 30 seconds, acknowledging that the system is disarmed. NOTE: If you hear 3 siren
chirps and see 3 light flashes when disarming, the vehicle was violated while you were away. Check the
LED for zone violation. See Operating Instructions, page 18 for “Violated Zone” explanation. This is a good
time to check your vehicle for possible damage. When disarming, the dome light will turn on for 30 seconds
if the Dome Light Supervision feature is connected (optional, part #775 required).
Silent Arming/Disarming
Should you desire not to have the siren chirp when arming and disarming, press and hold Button #1 for 3 seconds.
The system will perform all its usual arming/disarming functions, except there will be no arming and disarming
chirps. If the alarm is triggered, the siren will provide its normally loud sound. NOTE: If the lights flash
3 times after disarming, the vehicle has been violated as described in Operating Instructions, see page 18
for “Violated Zone”.
Remote Car Starter (
Optional equipment required)
A second channel built into this model can be activated while it is in the armed or disarmed mode. The second
channel can be used for remote engine starting (optional module required). Press Button #2 while the system
is armed or disarmed, the parking lights will flash once, and then will activate the installed accessory.
CAUTION: When remotely starting the vehicle while the system is armed from Button #2, shock and current sensing
will automatically shut off.
Car Finder
While the system is armed, press and release Button #3. The alarm will chirp 6 times and the parking lights
will flash. This is used to locate your vehicle in a crowded parking lot.
Optional Accessories
(Trunk Pop, etc., Opt. Part #775 required)
NOTE: When the alarm is disarmed, press Button #3 and the trunk will open. When the alarm is armed, press
and hold Button #3 for 2 seconds or until the trunk opens. If Button #3 is pressed and held, a ground output
signal is applied to the connected accessory for as long as this button is pressed. CAUTION: When opening
the trunk while the system is armed, shock and current sensing will shut off.
Instant Personal Panic
Press and release transmitter Button #4 to sound the instant panic siren. The lights and siren will activate
for 30 seconds and then shut off. To stop the siren before the 30 seconds, press any of the 4 transmitter
buttons.
LED Status Indicator
The LED (red light) provides valuable information about the system and is also a theft deterrent.
LED Status
LED Display
Armed
Flashing Slow
Disarmed
Off
Passive Arming
Flashing Fast (arming count down)
Valet
Constantly On
Violated Zone
Triggered Device
# of Flashes
Zone 2
On Board Shock Sensor
2 Flashes
Zone 3
External Sensors
3 Flashes
Zone 4
Voltage Sensor
4 Flashes
Zone 5
Door Switches
5 Flashes
Zone 6
Ignition
6 Flashes
Plug In Override Switch
In the event your remote control is lost, damaged or malfunctions; this switch allows you to disarm your system.
You must first open the door to the vehicle, turn ignition to the "ON" position, then press the override
switch. The siren will silence and you will now be able to start the engine. NOTE: A door must remain open
during this procedure.
OPERATING INSTRUCTIONS
1
3
2
4
BULLDOG
BUTTON #2
OPTION #2
BUTTON #4
PANIC
BUTTON #1
ARM/DISARM
BUTTON #3
OPTION #3
BUTTON #2
OPTION #2
BUTTON #4
PANIC
BUTTON #1
ARM/DISARM
BUTTON #3
OPTION #3
BULLDOG
