3
4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection.
Secure with wire ties as shown.
3. Lay upper twisted pair of wires over right wire as shown. Bring lower twisted pair of wires
up to meet the left wire as shown.
2. Twist upper wires together, twist lower wires together as shown.
1. When tying two separate wires together at their ends, strip back 1” of insulation on both
wires and separate the strands of wire as shown below.
Use this method ONLY when connecting two separate wires end to end.
Wire Tie
Electrical Tape
Wire Tie
LOCATING & MAKING CONNECTIONS
GROUND
Connect the ground wire #7 to a clean unpainted metal surface under the dash.
12 VOLT CONSTANT
Connect the wire marked #8 (co12 volts) to constant 12 volts located at the ignition harness.
NOTE: Silent Guard will emit a series of chirps to indicate the unit is powered up.
IGNITION INPUT / IGNITION OUTPUT
Locate the primary factory ignition wire located at the ignition harness near the steering wheel column,
cut in two. Connect the wire marked #1 (ignition input) to the vehicle’s factory ignition wire leading
from the ignition key side. Connect the wire #4 (ignition output) to the other half of the factory
ignition wire.
Note: Remove any paint from
under bolt.
Factory Bolt
Wire #7
