4
ANTENNA PLACEMENT
ANTENNA
For best results, run the antenna (small gauge unmarked wire
from the front of the unit) as straight as possible. Do not
place the antenna next to any metal parts or the vehicle’s
main computer control module.
MODULE
L.E.D.
FUEL INPUT
FUEL OUTPUT
IGNITION INPUT
IGNITION OUPUT
ST
AR
TER INPUT
ST
AR
TER OUTPUT
ANTENN
A
GR
OUND
+1
2 V
OL
T C
ONST
ANT
3
8
7
5
2
4
1
6
BUTTON #1
Disarm/Valet Off
BUTTON #2
Valet On
2
1
BULLDOG
Disarm
To be able to start the vehicle, press and release Button
#1. The LED will stop flashing and the Silent Guard will
emit one chirp. After disarming the unit, a 30 second window
will open to allow the user to start the vehicle. If the
vehicle is not started within 30 seconds the unit will
automatically immobilize your vehicle. After this 30 second
window has expired, and the LED will flash.
Arm
The Silent Guard is designed to automatically arm 30 seconds
after the ignition is turned off, unless the system is in
valet mode.
HOW TO USE YOUR REMOTE TRANSMITTER
Enter Valet Mode
Press and hold Button #2 for 5 seconds. The LED will light up constantly and the Silent Guard will emit two
chirps. While in valet mode, the Silent Guard will constantly chirp when the ignition is in the ON position.
Exit Valet Mode
Press and release Button #1. The LED will shut off and the Silent Guard will emit one chirp. The Silent Guard
will automatically arm in 30 seconds.
STARTER INPUT / STARTER OUTPUT
Locate the crank (starter solenoid) wire in the ignition harness, cut in two. Connect the wire marked
#2 (starter input) to the vehicle’s factory crank wire from the ignition key side. Connect the wire
marked #5 (starter output) to the other half of the factory crank wire leading out to the starter solenoid
(engine).
FUEL INPUT / FUEL OUTPUT
Locate the fuel pump power wire, in some vehicles you can find this wire located at the factory fuse
panel, it will be labeled fuel pump or injectors. If your vehicle doesn’t have this, please refer to
your vehicle’s wire schematic. Once you locate the wire, cut it in two. Connect wire #3(fuel pump input)
to the 12 volt supply going to the fuel pump ignition key side. Connect wire #6 (fuel pump output) to
the half of the factory fuel pump wire leading out to the fuel pump.
L.E.D.
Locate a good spot for the L.E.D., visible from all sides of the vehicle. If you wish to drill a hole,
use a 5/16 inch drill bit to mount the L.E.D. If you or your customer wishes not to have the L.E.D.
permanently mounted, use the included double-sided adhesive L-bracket to mount the L.E.D.
