MAKING WIRING CONNECTIONS
4. Insert the wire from the unit through the hole as shown.
6. Use electrical tape to wrap. Be sure to cover the wire about two inches on either side of the
connection. First pull the wire that you have just connected along side the wire you connected
to, tape and wire tie them together. Use this method for all connections.
CAUTION: All wires must be wrapped and taped.
5. Wrap the wire around one side then the other and finally around itself as shown.
1
2
3
Wire Tie
Electrical Tape
1. Strip back two inches of insulation on the wire from the keyless entry.
2. Strip back one inch of insulation on the wire you need to connect to.
One Inch of Bare Wire
Two Inches of Bare Wire
3. Separate the vehicle wire as shown. Make the separation large enough to fit the other wire
through.
1. When tying two separate wires together at their ends, strip back 1” of insulation on both
wires and separate the strands of wire as shown below.
MAKING END TO END CONNECTIONS
FOLLOW THESE INSTRUCTIONS
3
