Bull NovaScale Blade BL265, Installation And User Manual

Page: 30 / 92

14
NovaScale Blade BL265 - Installation and User's Guide
2.2 Turning on the blade server
After you connect the blade server to power through the Blade Chassis, the blade server
can start in any of the following ways:
• You can press the power-control button on the front of the blade server (see Blade
server controls and LEDs on page 11 ) to start the blade server.
Notes
•
Wait until the power-on LED on the blade server flashes slowly before
pressing the power-control button. While the service processor in the
blade server is initializing and synchronizing with the management
module, the power-on LED flashes rapidly, and the power-control button
on the blade server does not respond. This process can take
approximately two minutes after the blade server has been installed.
• While the blade server is starting, the power-on LED on the front of the
blade server is lit and does not flash. See Blade server controls and
LEDs on page 11 for the power-on LED states.
•
If a power failure occurs, the Blade Chassis and the blade server can be configured to
start automatically when power is restored through the management module.
• You can turn on the blade server remotely by using the management module.
•
If the blade server is connected to power (the power-on LED is flashing slowly), the
blade server is communicating with the management module, the operating system
supports the Wake on LAN feature, and the Wake on LAN feature has not been
disabled through the management module, the Wake on LAN feature can turn on the
blade server.