Bull Escala EPC1200, Connecting Manual, Page: 63 / 224

6-33
Console Cabling Requirements
Cabling Instructions
Documentation References
Installing Your Explora Family System
17” Professional Color Monitor – User’s Guide
Workstations BQX 4.0.
Installation
Warning: Do not plug the power cords on the X Terminal box and on the monitor front side
before being asked to do so:
1. Install the memory extension and the PCMCIA board which has been previously write-
enabled.
See section §5 of Installing Your Explora Familly System documentation.
2. Connect the video cable between the X Terminal box and the monitor.
3. Connect the X Terminal to the Superstack II Hub 10 using a RJ45/RJ45 cable.
4. Connect the X Terminal box:
to the console concentrator using RS232 cables (CBL1912, CBLG106–2000),
elsewise to the S1 port of an EPC node using RS232 cables (CBL1912. CBLG105–1800)
5. Connect the keyboard and the mouse on the X terminal box.
6. Plug the power cord on the X Terminal box and on the monitor.
7. Power ON the X Terminal box.
8. Power ON the monitor (Green LED is switched on).
Refer to the 17” Professional Color Monitor User’s Guide for further information on LEDs
and command switches.
9. You can stop the automatic starting of the X Terminal by typing the ESC key after
Power–up tests have completed.
10.Once the prompt > has come, type the command se and press ENTER to get the main
menu.
11. Select
keyboard
in order to set the type of keyboard (IBM PS/2 or N101).
12.Select Monitor to set the resolution frequency of the monitor.
Warning: Selecting a wrong screen resolution can damage your monitor. Make sure your
selection is supported by your monitor. See the 17” Professional Color Monitor User’s
Guide.
13.Select Network then set the following parameters:
Get IP Address from: NVRAM
Terminal IP Address: @IP of XT
Subnet Mask: Subnet Mask
14.Select
Boot
then set the following characteristics as follows:
TFTP Boot Directory: /local/
TFTP Order: Disabled
NFS Order: Disabled
MOP Order Disabled
Local Order 1
15.Select Done then Reboot .