Bull Escala EPC1200, Connecting Manual, Page: 55 / 224

6-25
Console Cabling Requirements
PowerConsole Configuration Procedure
Update the file /etc/hosts with the different addresses configured on the CS/2600 server:
@IP0 (CS/2600 server address), @IP1 (J1/Node1 S1 address),
@IP2 (J1/Node2 S1 address), etc.
For example:
120.184.33.10 CS–2600 # @IP0
120.184.33.11 Node1_cons # @IP1
120.184.33.12 Node2_cons # @IP2
Examples of Use
1. From the PowerConsole, open an AIX window (dtterm, xterm, aixterm) one for each
node connected to the CS/2600 terminal server:
– Establish the connection to S1 node by striking the telnet command with the
associated address @IP1, @IP2, etc.:
# telnet @IP1 for Node #1 in first window
# telnet @IP2 for Node #2 in second window
etc.
2. To disconnect a session from a PowerConsole window to a node connected with
CS/2600 server port,
a. strike Control and ”]”:
<CTRL>+]
b. The session is disconnected and one returns to the telnet program. At this point, key
in ”q” or quit to exit the telnet (after telnet>):
telnet> q <ENTER>
3. To disconnect a monitoring CS/2600 session established on the PowerConsole within
the cu command,
key in the two characters ”tilde” and ”period”:
~.
CAUTION:
In the monitoring CS/2600 session on the J0 port, do not exit this session with the
commands logout or listen. Otherwise, the J0 is no longer available for monitoring. In
this case, a hardware reset of CS/2600 has to be made to re-enable this port (J0), and
consequently the other ports are disabled.