14
NATURAL GAS (NG) CONNECTION INSTRUCTIONS
Refer to the following instructions and illustrations for typical gas supply connections.
We strongly suggest professional installation and
hook-up of the Gas BBQ.
IMPORTANT:
Before connecting grill to gas source, make sure BBQ Grill control knobs are in “OFF” position.
Be sure to follow instructions for connecting an appliance to a fixed fuel piping system specifying the use of a rigid pipe, semi-rigid tubing, and/or a
connector that complies with the Standard for Connectors for Outdoor Gas Appliances and Manufactured Homes, ANSI Z21.75 For post-mounted
outdoor cooking gas appliances, in-ground metallic posts shall be protected against corrosion as warranted by soil conditions. A suitable coating of
corrosion protection will retard the effects of corrosion and help your Bull purchase last longer.
IMPORTANT:
Bull Outdoor Products does not recommend the use of any quick
connect fittings or lines to the
unit. Use of these types of fittings or lines could cause low gas flow and greatly reduce the performance of the
unit.
1)
Do not use Teflon ® tape or pipe sealant on any flare ends because
you will not obtain a leak-free seal.
2)
Remove plastic cap from regulator installed on grill.
3)
Attach stainless steel flex line 3/8” flare-female end to the regulator.
4)
``Attach the other end of flex line to shut-off valve through a nipple.
5)
Attach a shut-off valve to gas supply pipe.
IMPORTANT INSTALLATION GUIDELINES:
1)
Vents must be provided for combustion air and ventilation on both sides of built-in cabinet.
2)
When choosing a location for your gas grill, keep in mind that it should never be located under any overhead combustible construction.
3)
The sides and back of the grill should not be any closer than
21 inches
to combustible construction as shown in drawing below.
4)
There must be a minimum of
6 inches
counter space behind the grill in order to allow the grill hood to clear properly.
5)
Do not use any combustible materials for this construction.
SIDE BURNER
NATURAL GAS CONNECTION PLUMBING TO SIDE
BURNER (THESE PARTS ARE NOT PROVIDED BY BULL)
•
1/2 INCH ‘TEE’ FITING
•
1/2 INCH NIPPLE
•
SHUT-OFF VALVE
•
1/2 INCH NIPPLE FROM NATURAL GAS SOURCE
•
STAINLESS STEEL FLEX LINE
NO COMBUSTIBLE
CONSTRUCTION
MATERIALS ALLOWED
WITHIN 21 INCHES OF
THE BACK AND BOTH
SIDES OF SIDE
BURNER OR GRILL
STAINLESS STEEL FLEX LINE
3/8-1/2 INCH NPT ADAPTERS
(QUANTITY 2)