28
TROUBLESHOOTING
NEVER SMOKE DURING TROUBLESHOOTING
IF GRILL FAILS TO OPERATE PROPERLY
1)
Turn off gas at source, turn control knobs to “OFF”, and wait five minutes before trying again.
2)
Check gas supply/connections. Repeat lighting procedure. If Grill still fails to operate properly,
TURN “OFF” GAS AT SOURCE, TURN
CONTROL KNOBS TO “OFF”
, wait for grill to cool, and check for the following potential causes below and how to address:
MISALIGNMENT OF BURNER TUBE(S) OVER ORIFICE(S) / CORRECTION:
Reposition burner tube to properly seat over orifice.
OBSTRUCTION IN GAS LINE /CORRECTION:
1) Remove fuel line from grill.
2) Open gas supply for one second to blow any obstruction from fuel line.
3) Close off gas supply at source and reconnect fuel line to grill.
PLUGGED BURNER ORIFICE/ CORRECTION:
To access a Burner Orifice:
1)
Start by following to the instructions on pages 23 and 24 to allow Burner removal and inspection.
2)
Next, carefully lift each burner up and away from gas valve orifice. Remove the orifice from each burner up and away from gas valve
and gently clear any obstruction with a fine wire. If an obstruction is suspected in gas valve(s) or gas valve bracket, please contact your
gas grill dealer or gas appliance service person for assistance.
3)
Re-install the orifice.
4)
Per page 26 reinstall burners over orifices and seat each burner peg. Perform Burner ignitor test to confirm it is working.
5)
Replace cooking components and grease collectors before attempting to light grill.
MISALIGNMENT OF IGNITER ON BURNER / CORRECTION:
• Check for proper position of electrode tip. The tip of the electrode should be pointing forward toward the front and free from grease for
spark discharging. The ignition wire should be firmly connected to the valve ignition and electrode.
• Replace the ignition wire if the wire is broken or cracked. With gas supply closed and all control knobs set to “OFF”, check each
positive igniter individually for presence of spark at electrode. In turn, push each control knob in fully and rotate about 1/4 turn to the left
(counter clockwise) until click is heard; the trigger hitting the strike block should produce a blue spark at the electrode tip. Return control
knob to “OFF” before checking next igniter.
IF RE-IGNITION IS NECESSARY
While the gas grill is still hot, you must wait for a minimum of five minutes before commencing to re-ignite (this allows accumulated
gas fumes to clear). If all checks/corrections have been made and gas grill still fails to operate properly, consult your grill dealer or
gas appliance service person.
FLAME COLOR
Once the entire burner is operating, check the flame color to be sure it is mostly blue (some yellow color will be present because
of impurities in the fuel).
• If the flame is golden or yellow in color the reason could be seasoning salts, oil film, or other foreign matter on burner.
CORRECTION:
Remove burners and use compressed air to blow out residue from interior of burner.
FLASH BACK
When fire occurs in and around the burners, immediately turn off gas at its source and turn the control knob(s) to “OFF”.
Wait until the grill has cooled, then clean the burners and burner ports as described on page 19.
Summary of Contents for BRAHMA 57568
Page 7: ...7 ...
