{
CAUTION:
A safety belt that is improperly routed, not
properly attached, or twisted will not provide
the protection needed in a crash. The person
wearing the belt could be seriously injured.
After installing the seat, always check to be
sure that the safety belts are properly routed
and attached, and are not twisted.
Do not put the stowable seat in so that it faces
rearward. The stowable seat has to go in before the
rear convenience center. See Rear Convenience
Center on page 2-43 for more information.
The stowable seat has seat position labels, located on
the back of the seat, showing where the seat must go.
The seat must be placed in the proper location for the
legs to attach correctly.
Make sure that the seatback is folded forward before
beginning this procedure.
1. Remove the nuts from the screws.
2. Place the stowable seat on the vehicle floor so
that the brackets are placed over the screws.
3. Reinstall the nuts back onto the screws.
Torque to approximately 18 lb ft (25
Y
).
4. Try to raise the seat to make sure that it is
locked down.
5. Raise the seatback to its upright position.
Push and pull on the seatback to make sure
that it is locked into place.
1-21
Summary of Contents for 2006 Rendezvous
