Bühler technologies Nivotemp NT M-XP Series, Installation And Operation Instruction Manual

Page: 35 / 59

Bedienungs- und Installationsanleitung
Installation- and Operation Instruction
Nivotemp NT M-XP
BX100023, 02/2011 Art. Nr. 90 32 040
35
4.6.3 Re-assignment of the Switching Outputs
The re-assignment of the switching outputs is explained for switching output 1. The procedure for re-
assigning further switching outputs follows the same steps.
The switching outputs 1 to n can be assigned to level or temperature measurement. The assignment
affects the appearance of menus
Level
oil and
Temperature
tEMP . Switching output OUT 1 is assigned
to level measurement as factory setting.
Example: OUT 1 should be assigned to temperature measurement. For this, set r.ou1 to tEMP . As a result,
sub-menu out1 shifts from main menu
Level
to main menu
Temperature
. The procedure for
setting parameters is not affected at all.
NOTE
!
After re-assigning the switching output, check all corresponding settings! The set values are
not adjusted automatically! The assignment of the status LEDs does not change.
Assignment of the switching outputs to temperature or level measurement
level measurement temperature measurement
Further switching outputs are assigned to level or temperature measurement in the same way as switching
output 1.
¾ Follow the same steps as described for switching output OUT 1.
4.6.4 Setting the Display Refresh Rate
Depending on the application, the display refresh rate can be set. The display can be shut off as well. In
this case, the function of the LED remains active.
The following options are available:
fast medium slow display off
Note:
−
Error messages are displayed even if the display is shut off.