9
Timer function
Touch the surface of MODE Button to enter the timer mode.
The LED
display shows M 00:00S. M = Minute S = Second - The maximum time is 90 mins
59 sec.
Setting the timer
1) Touch the surface of TARE/ SET Button , the minute count will blink
.
2) Touch the surface of SYSTEM Button to adjust the minutes. Each touch
correspond to one minute and if touch the surface of the button, the minutes
will grow continuously.
3) Touch the surface of TARE/ SET button, the second count will blink
.
4) Touch the surface of SYSTEM button to adjust the seconds. Each
touch correspond to one second and if touch the surface of the button, the
seconds will grow continuously.
5) Touch the surface of TARE/ SET button again to confirm the time.
6. Touch the surface of SYSTEM button to start the time count down.
7. When the time is up, touch the surface of SYSTEM Button to stop the
buzzer. If no button is touched the buzzer works just for one minute before
to stop automatically and the display remain on for 30 seconds.
NOTE: When you enter the timer MODE , it shows the previous time
setting. You may follow the above steps to re-adjust the time.
REPLACE BATTERY
When “Lo ” blinks on the display, the battery must
be replaced. The scale requires 3 AAA (1.5V) bat-
teries.The battery compartment is located on the
underside of the scale.
To replace the battery, you have to open the com-
partment cover and remove the used battery. Before
you replace the new battery into the compartment,
please make sure the battery is installed to the cor-
rect po) / (-).
C
D
E
F
G
AAA
x 1,5 v
AAA
x 1,5 v
AAA
x 1,5 v
