Buffalo Tools HIT140, Assembly & Operating Instructions

Page: 7 / 22

7
CAUTION ! ! ! !
1. WORKING ENVIRONMENT
1
）
BEST TO WORK IN DRY PLACES, NOT TOO WET OR RAINY OR FULL OF DUST ETC.
2 ） KEEP TEMPERATURE BETWEEN 14
°
F TO 140
°
F.
2. SAFETY
1
）
Please keep the machine cool, make sure the fan is working and not blocked.
2
）
The working voltage is AC 120V±15%, if lower or higher than this, it will cause damage.
3
）
The welder will automatic recover and work again when cooled down.
3.
USE CORRECT CONSUMABLES
During welding, the working temperature is very hot and will cause the head of torch to be easily damaged. Please
change often.
Installation
1. Power requirement
AC single phase 120v (110-120V), 60HZ with a 20 amp time delayed fuse or circuit breaker is required.
DO NOT OPERATE THIS UNIT if the ACTUAL power source voltage is less than 105 volts AC or greater than
132 volts AC.
• High voltage danger from power source! Consult a qualified electrician for proper installation of receptacle. This
welder must be grounded while in use to protect the operator from electrical shock.
• Do not remove grounding prong or alter the plug in any way. Do not use any adapters between the welder’s
power cord and the power source receptacle. Make sure the POWER switch is OFF when connecting your
welder’s power cord to a properly grounded 120Vac, 60Hz, single phase, 20 amp power source.
2. Extension cord
It is strongly recommended that an extension cord should not be used because of the voltage drop it produces.
This drop in voltage can affect the performance of the welder. If you need to use an extension cord it must be a