B T L - 5 0 0 0 S E R I E S
U S E R ' S M A N U A L
p a g e 9 o f 5 6
2 . 3
U N P A C K I N G A N D A S S E M B L Y
Inspect the box for damage and report any damage to carrier and your distributor. Do not proceed with installation and
assembly if box is damaged.
Unpack the equipment and place it on a stable horizontal surface suitable for the equipment's weight. Always position
the unit out of direct sunlight as this may make the touch screen difficult to read. Always position the unit away from
direct heat sources such as radiator or room heater. Cooling of the equipment is provided for by forced air circulation.
Cooling vents are located on the rear panel and at the bottom of the equipment and must not be covered. Do not
position the equipment on a soft surface which may obstruct air flow to the bottom cooling vents. Do not put any heat-
producing devices or objects containing water or other liquid on the equipment. Do not place the equipment close to
devices producing strong electromagnetic, electric or magnetic field (diathermy, X-rays, etc.), as equipment
electronics could be undesirably influenced. In case of questions please call your distributor or service agent.
Retain original packaging to ensure safe transportation of the device.
Attaching the accessory holder:
Remove the protective caps from the holes on a side of the unit. Use a screwdriver to gently slide the blade under the
cap and pry it out. Align the accessory holder and secure with screws (supplied) from below. Do not over-tighten.
PLUG THE DEVICE DIRECTLY IN THE MAINS SOCKET. DO NOT USE ANY MULTI-CONNECTION EXTENSION
CABLE OR ADAPTER.
Check of correct mains voltage:
Before first connection of the equipment to the mains check if the mains voltage switch (
27
) located at the bottom of
the equipment is in the position corresponding to local voltage standards, either in the "230V" or "115V" position. For
details, see the note " Switching the equipment to different mains voltage " in
6 MAINTENANCE AND SAFETY
INSTRUCTIONS
.
In case of questions please call your distributor or service agent.
Switching the device on:
Plug the mains cable into the mains socket and switch the
O
/
I
rocker switch (
21
) on the rear panel to the
I
position.
Press the ON/OFF switch (
7
) on the front panel. The ON status is indicated by the backlighting of the switch
(7)
. The
system will then run a self-test. If the self-test finds no faults, the screen will display the equipment type and it is ready
for use -- see note below.
