9
344082
BT00641-a
>3s
>3s
BEEP
EXIT
EXIT
BEEP
BEEP
>3s
>3s
BEEP
EXIT
EXIT
BEEP
BEEP
BEEP
>3s
BEEP
BEEP
>3s
>3s
>3s
BEEP
EXIT
EXIT
BEEP
BEEP
>3s
>3s
BEEP
EXIT
EXIT
BEEP
BEEP
BEEP
>3s
BEEP
BEEP
>3s
-EN
TECHNICAL SHEETS
DOOR STATUS function
PUSH TO TALK function
PAGING function
HANDSFREE function
This function notifies the status of the door lock. If open, the “door lock LED” flashes, if
closed, the LED stays off.
NOTA:
è attivabile solo se l’impianto lo prevede; NON è attivabile contemporaneamente
alla OFFICE function.
Enable/disable key sound
In the base configuration, when a key is pressed, a beep is emitted. This function may be
disabled/enabled with the following procedure:
If the entrance panel is in a particularly noisy position, during the conversation it will
be possible to enable the “PUSH TO TALK” function, which will provide a better quality
of communication.
To enable the PUSH TO TALK function during the conversation proceed as follows:
- Press the Connection key for at least 2 seconds, to enable the communication with the
entrance panel.
The LED stays green.
- Release the key to listen to the entrance panel.
The LED turns red.
- To end the connection press the Connection key briefly.
The LED turns off.
This function can be used to send voice messages using the microphone of the device
through the speakers of the sound system. To activate briefly press the ”Connection” key
while the device is in the idle condition. The activation of the function is confirmed by the
green LED coming on. To DISABLE the function press the ”Connection” key again.
The HANDSFREE function automatically activates the microphone and the loudspeaker
when a call is received, without the need for pressing the Connection key to answer (the
connection is automatically established when the call is received).
To ENABLE the function
To ENABLE the function
To DISABLE the function
To DISABLE the function
