VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
37
display will cycle through the CTCSS tones as they are being tested. Once the frequency of the
received CTCSS tone is determined, the "CT" indicator will stop flashing.
Press the
key to save the scanned tone into memory then press the
key to exit the
menu.
Don't forget to set menu 11 back to OFF when the CTCSS tone is no longer required.
Scanning for a DCS tone
1.
Press the
key to enter the menu.
2.
Enter
on your numeric keypad to come to Menu 10: R-DCS
3.
Press the
key to select.
Insure you have a tone activated (and it is not off)
4.
Press the
to begin DCS scanning
A flashing "DCS" will be in the left status display to indicate the radio is in DCS scanning mode. In
this mode, whenever the radio is receiving an RF signal on the selected MR channel, the lower
display will cycle through the DCS codes as they are being tested. Once the bits of the received
DCS code are determined, the "DCS" indicator will stop flashing.
Press the
key to save the scanned tone into memory then press the
key to exit the
menu.