Synergy 3500 user guide ~ 3rd Edition ~ 21st October ’02 ~ 4461
13
Before you use your Synergy 3500 for
the first time, it is important to have
the handset batteries fully charged.
The batteries need to charge
continuously
for at least 16 hours
to reach full charge
.
Place the handset on the base. The
red charging light will come on. The
handset comes pre-registered to the
base station as
SYNERGY HS1
. This is
shown on the display. The
icon and
the battery icon are shown on the
display. Once the handset is fully
charged, the display shows a full
battery symbol.
3
Charge the handset batteries
for at least 16 hours
2
Install the rechargeable
batteries in the handset
Battery low warning
If the handset battery symbol is empty
and flashing, and you hear a warning
beep every 10 seconds, you will need
to recharge your handset before you
can use it.
The handset uses two rechargeable
Nickel Metal Hydride (Ni-MH) AAA
batteries which are supplied. Take
care to insert the batteries as shown
and then fit the battery cover (the
battery cover may be found in the
packaging with the batteries).
Please note that the red charging light
will remain on even when the batteries
are fully charged.
BATTERY LEVELS
WEAK
HALF-FULL
FULL
Note
The
symbol on your handset display
indicates when you are in range of
the base station. If the symbol flashes
and you hear a warning beep, you
are out of range and will need to move
closer to the base station.
SETTING
UP
