Electric drive motor 1700
Tightening torques – Drive motor
© BT
Repair manual
SWE100, 120, 120L, 120S, 140, 140L, 200D
9 – 5
Order no..
Date
Valid from serial no.
T code
258946-120
2012-08-30
6061850-
841×842×843
9.3 Tightening torques – Drive motor
The drive motor tightening torques are depicted in the figure below:
9.4 Installing the temperature sensor
1.
Cut off the wiring to the broken temperature sensor, and splice on
the new one.
2.
Place the new temperature sensor on the motor.
3.
Carefully clean the area and make sure all surfaces are dry.
4.
Apply plastic steel by pushing out a string that is half the length of
the curing agent compared to the putty, then carefully mix the two
(be careful not to mix a larger amount than will be used in 5
minutes).
5.
Apply a layer of plastic steel, at least 4 mm thick, and make sure the
repaired surface has an overlap of at least 2 cm.
6.
Secure the steel plastic with masking tape and allow it to cure.
7.
Remove the masking tape.
The temperature sensor should now be completely covered by
steel plastic.
8.
Following curing, it is recommended to apply another layer of
plastic steel.
T30
T30
Nm
3.5
10 mm
8
Nm
3
+ 0,5
Nm
https://www.besttruckmanuals.com/
