29
On-Air 1250 Classic user guide ~ 1st Edition ~ 7th August ’01 ~ 4073
Wall mounting
2
Once slotted into the rear
of the base, slide upwards
to lock into position.
1
Push the base-mount
forward onto the rear
of the base.
If wall mounting your BT On-Air 1250 Classic,
use this guide for position.
•
Make sure that you are not drilling into any
hidden wiring and check that the power
cable will reach from the mains socket to
the charger. Switch the power adaptor off at
the mains and remove the adaptor plug
from its socket.
•
Drill two holes 25mm deep using a 3mm drill,
122mm apart to take the wall plugs.
•
Put wall plugs into the drill holes and then
insert both screws. Leave 2-3mm between
the head of the screw and the wall. You are
now able to mount the base to the wall.
•
Fit the base onto the two screws. If necessary,
tighten or loosen the screws for the best fit.
•
Put the handset back in the base and switch
the power back on at the wall socket.
122 mm
WALL
WALL PLUG
SCREW
122mm
2
1
