Page | 5
Diesel vehicles:
This ECM tune switching menu is found on AutoSync main menu, page 1. This menu
allows you to control EFILive DSP or EZ Lynk SOTF tune level. Simply tap whichever tune you want to
switch to, and the DSP/SOTF mode will immediately be changed. The currently selected tune will be
highlighted with a
“( )”
around the number, as shown in the picture below.
NOTE: requires additional AutoSync DSP/SOTF tune control wiring kit, sold separately. See page 17 of
this instruction manual for the AutoSync DSP/SOTF wire kit installation guide.
Gas vehicles:
The icon that shows “ECM Tune Switching” in the picture below only shows on diesel
vehicles. When AutoSync is plugged into a gas vehicle, this icon will be replaced with “AFM:
Enabled/Disabled”. To disable the Active Fuel Management mode on your gas vehicle, set this to
“DISABLED”. This setting will be remembered permanently, you do NOT have to set AFM to disable
every time you drive the vehicle.
Strobe Lights
– Found on page 1 of the AutoSync main menu. This activates exterior strobe light mode.
This will rapidly flash all exterior lighting (headlights, front turn signals, rear turn signals, CHMSL, reverse
lights, fog lights) in an alternating pattern. CHECK LOCAL LAWS regarding use of this feature! In most
areas, using vehicle lighting in this manner on public roadways is considered ‘impersonating a police
officer’.
2017+ vehicles, this feature usually only works with key on, engine off. If the engine is running
and you try to turn the strobe lights on, the button will say “Strobe Lights: Not Avail.”
We have recently developed a custom unlock method to allow strobes (and
work lights) with engine running on 2017+ vehicles! Currently, it is required to
have purchased our BCM tuning to gain access to this unlock method.